Журнал Российского общества по неразрушающему контролю и технической диагностике
The journal of the Russian society for non-destructive testing and technical diagnostic
 
| Русский Русский | English English |
 
Главная Текущий номер
28 | 03 | 2024
2019, 01 январь (January)

DOI: 10.14489/td.2019.01.pp.032-037

Коновалов А. М., Кугушев В. И., Яковлев А. Ю.
ИМПЕДАНСНЫЙ ДАТЧИК ДЛЯ НЕРАЗРУШАЮЩЕГО КОНТРОЛЯ ЖЕСТКИХ МЕТАЛЛИЧЕСКИХ КОНСТРУКЦИЙ
(с. 32-37)

Аннотация. Представлено описание конструкции преобразователя импедансного дефектоскопа, имеющего шток, разделенный поперек на две части, соединенные пружинами. Это позволяет верхней части штока, возбуждаемой пьезоэлектрическим элементом, свободно генерировать колебания и передавать их на объект контроля через нижнюю часть, плотно прижатую к твердой поверхности объекта. Изменение массы верхней части штока и жесткости пружин позволяет подстраивать частоту генерируемых колебаний под частоту собственных колебаний объекта контроля и выделять их амплитуду из общего спектра механических колебаний. По изменению амплитуды собственных колебаний осуществляется дефектоскопия объекта контроля на наличие и развитие трещин и остаточных напряжений. Приведены результаты, демонстрирующие работу датчика как в раздельном, так и в совмещенном режиме.

Ключевые слова:  импедансный преобразователь, шток, пьезоэлектрический элемент, собственные колебания, дефектоскопия, интегральный автоматизированный контроль.

 

Konovalov A. M., Kugushev V. I., Yakovlev A. Yu.
IMPEDANCE SENSOR FOR NON-DESTRUCTIVE TESTING OF RIGID METAL STRUCTURES
(pp. 32-37)

Abstract. The article describes impedance flaw detector transducer that has a rod divided across into two parts connected with springs. Thus, upper portion of the rod excited by piezoelectric element can freely generate oscillations and transmit them to the object under test through lower part tightly pressed to solid surface of the object. Change in the mass of the upper portion of the rod and rigidity of springs allows to tune frequency of generated oscillations to frequency of natural oscillations of the object under test, and to separate their amplitude from the general spectrum of mechanical oscillations. This may be done if the sensor consists of two transducers, transducer-oscillation generator and transducer-receiver installed permanently in different parts of the object. Flaw detection of the object under test for availability and development of cracks and residual stresses is made with respect to variation of the amplitude of natural oscillations. Use of the suggested sensor enables to carry out an integrated non-destructive testing of metal structures in whole or their elements separately, including those that have no direct access. This kind of testing may be easily computerized. Results demonstrating operation of the sensor both in separate and combined mode are presented.

Keywords: impedance transducer, rod, piezoelectric element, natural oscillations, flaw detection, integrated computerized testing.

Рус

А. М. Коновалов, В. И. Кугушев, А. Ю. Яковлев (АО «ЦКБ МТ «Рубин», Санкт-Петербург, Россия) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.  

Eng

A. M. Konovalov, V. I. Kugushev, A. Yu. Yakovlev (CDB МE Rubin, Sant-Petersburg, Russia) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.  

Рус

1. Ботаки А. А., Ульянов В. Л., Шарко А. В. Ультразвуковой контроль прочностных свойств конструкционных материалов. М.: Машиностроение, 1983. 80 с.
2. Писаренко Г. С. Колебания упругих систем с учетом рассеяния энергии в материале. Киев: Изд-во Академии наук Украинской ССР, 1955. 238 с.
3. Ультразвук. Маленькая энциклопедия / гл. ред. И. П. Голямина. М.: Сов. энцикл., 1979. 400 с.
4. Броек Д. Основы механики разрушения: пер. с англ. М.: Высш. шк., 1980. 368 с.
5. Вольмир А. С. Нелинейная динамика пластинок и оболочек. М.: Наука, 1972. 432 с.

Eng

1. Botaki A. A., Ul'yanov V. L., Sharko A. V. (1983). Ultrasonic control of the strength properties of structural materials. Moscow: Mashinostroenie. [in Russian language]
2. Pisarenko G. S. (1955). Oscillations of elastic systems, taking into account the energy dissipation in the material. Kiev: Izdatel'stvo Akademii nauk Ukrainskoy SSR. [in Russian Language]
3. Golyamina I. P. (Ed.) (1979). Ultrasound. Little Encyclopedia. Moscow: Sovetskaya entsiklopediya. [in Russian language]
4. Broek D. (1980). Fundamentals of Fracture Mechanics. Moscow: Vysshaya shkola. [in Russian language]
5. Vol'mir A. S. (1972). Nonlinear dynamics of plates and shells. Moscow: Nauka. [in Russian language]

Рус

Статью можно приобрести в электронном виде (PDF формат).

Стоимость статьи 350 руб. (в том числе НДС 18%). После оформления заказа, в течение нескольких дней, на указанный вами e-mail придут счет и квитанция для оплаты в банке.

После поступления денег на счет издательства, вам будет выслан электронный вариант статьи.

Для заказа скопируйте doi статьи:

10.14489/td.2019.01.pp.032-037

и заполните  форму 

Отправляя форму вы даете согласие на обработку персональных данных.

.

 

Eng

This article  is available in electronic format (PDF).

The cost of a single article is 350 rubles. (including VAT 18%). After you place an order within a few days, you will receive following documents to your specified e-mail: account on payment and receipt to pay in the bank.

After depositing your payment on our bank account we send you file of the article by e-mail.

To order articles please copy the article doi:

10.14489/td.2019.01.pp.032-037

and fill out the  form  

 

.

 

 
Поиск
На сайте?
Сейчас на сайте находятся:
 21 гостей на сайте
Опросы
Понравился Вам сайт журнала?
 
Баннер
Rambler's Top100 Яндекс цитирования