Журнал Российского общества по неразрушающему контролю и технической диагностике
The journal of the Russian society for non-destructive testing and technical diagnostic
 
| Русский Русский | English English |
 
Главная Archive
28 | 03 | 2024
2019, 01 January

DOI: 10.14489/td.2019.01.pp.038-041

 

Eminov R. A., Mursalov N. Z., Abdullaeva S. N.
TWO WAVELENGTHS MODEL METHOD FOR DETERMINATION OF OIL EMULSION DEPTH ON THE SEA SURFACE IN INFRARED BAND
(pp. 38-41)

Abstract. The suggested two wavelengths method for determination of oil emulsion depth on the sea surface in infrared band is described. The possibility of utilization of known single wavelength method for determination of depth of oil emulsion on the sea surface is analyzed. It is noted that that this method don’t allow to derive the simple analytical formulaes for calculation of emulsion depth and level of emulsification. The further development of single wavelength model for determination of oil emulsion width on the sea surface by transition to two wavelengths allows to obtain the analytical model formulaes for separated computing of low depths of oil emulsions. On the basis of known single wavelength method the two wavelengths method is suggested which in the case of low exponential parameter allows to derive the analytical formulae for calculation of above said parameters. The possibility for decrease of volume of carried out calculations by way of pair wise realization of analytical calculation of one of said parameters and further graphical determination of other one is shown for special cases. It is noted that error of suggested two wavelengths method mainly depends on error of approximation of exponential function used in single wavelength method of measurements. According to given estimates if the parameter of exponent is less than 0.1, the accuracy of method equals to 1…2 % which is acceptable. But if said parameter reaches 0.2 the error of calculation comes near to 10…12 % and further increase of error becomes unacceptable.

Keywords: oil emulsion, depth of film, two wavelength method, level of emulsification, sea pollution.

 

Eminov Ramiz Ahmed oglu (Azerbaijan State University of Oil and Industry, Baku, Azerbaijan Republic) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.
Mursalov Nemat Zakir oglu (State Water Problems Institute, Baku, Azerbaijan Republic) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.
S. N. Abdullaeva (Azerbaijan State University of Oil and Industry, Baku, Azerbaijan Republic) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.

 

 

1. Bonn Agreement. (1999). Counter Pollution Manual, (1 – 3). London.
2. Wettle M., Daniel P. J., Logan G. A. and Thankappan M. (2009). Assessing the effect of hydrocarbon oil type and thickness on a remote sensing signal: A sensitivity study based on the optical properties of two different oil types and hymap and quickbird sensors. Remote Sensing of Enviroment, 113(9), pp. 2000-2010.
3. Otremba Z. and Piskozub J. (2004). Modelling the bidirectional reflectance distribution function (brdf) of seawater polluted by an oil film. Optics Express, 12(8), pp. 1671-1676.
4. Clark R. N., Swayze G. A., Leifer I. et al. (2010). Using imaging spectroscopy. US Geological Survey open-File Report, 1167, pp. 1-51.
5. Brown C. E., Fruhwirth M., Fingas M. F. et al. Oil slick thickness measurement: a possible solution to a long standing problem. Available at: https://www.bsee.gov/sites/bsee.gov/files/osrr-oil-spill-response-research//157af.pdf
6. Sicot G., Lennon M., Miegebielle V., Dubucq D. (2015). Estimation of the thickness and emulsion rate of oil spilled at sea using hyperspectral remote sensing imagery in the SWIR domain. The international Archives of the Photogrammetry. Remote Sensing and Spatial information Sciences, Vol. XL-3/W3. ISPRS Geospatial Week. France: La Grande Motte, pp. 445-449.

 

This article  is available in electronic format (PDF).

The cost of a single article is 350 rubles. (including VAT 18%). After you place an order within a few days, you will receive following documents to your specified e-mail: account on payment and receipt to pay in the bank.

After depositing your payment on our bank account we send you file of the article by e-mail.

To order articles please copy the article doi:

10.14489/td.2019.01.pp.038-041

and fill out the  form  

 

 

 
Search
Баннер
Rambler's Top100 Яндекс цитирования