10.14489/td.2026.06.pp.072-078

2026, 06 June

DOI: 10.14489/td.2026.06.pp.072-078

Petrov V. V., Bakholdin A. V.
IMPROVING THE STABILITY OF NDIR CARBON MONOXIDE SENSOR MEASUREMENTS BY USING A CATALYTIC FILTER
(pp. 72-78)

Abstract. This article examines the limited measurement stability of non-dispersive infrared (NDIR) carbon monoxide sensors due to zero-signal drift and cross-sensitivity to interfering components of the gas mixture. It is shown that traditional reference signal generation schemes based on an additional optical channel do not provide the required measurement stability due to uneven degradation of optoelectronic components, contamination of optical surfaces, and temperature effects. An alternative approach to generating a reference signal for an NDIR carbon monoxide sensor is proposed. This approach utilizes a heterogeneous catalyst that neutralizes carbon monoxide through an oxidation reaction. The operating principle of the proposed gas-dynamic and optical design is discussed, and a comparative analysis with traditional NDIR sensor designs is conducted. It is established that the use of a catalytic filter allows for the generation of a reference signal that is insensitive to carbon monoxide and reduces the impact of cross-sensitivity to water vapor. The obtained results can be used in the development of high-precision NDIR sensors for use in detecting trace concentrations of carbon monoxide.

Keywords: NDIR sensor, carbon monoxide, carbon monoxide, catalytic filter, hetero-geneous catalysis, CO oxidation.

+ - About the Authors Click to collapse

V. V. Petrov, A. V. Bakholdin (ITMO National Research University, St. Petersburg, Russia) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра. , Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.

+ - References Click to collapse

1. Chief State Sanitary Physician of the Russian Federation. (2021). Resolution No. 2 of January 28, 2021 "On approval of sanitary rules and norms SanPiN 1.2.3685-21 'Hygienic standards and requirements for ensuring safety and (or) harmlessness of environmental factors for humans' (pp. 1–988). [in Russian language].
2. RMG 29-2013: State system for ensuring uniformity of measurements. Metrology. Basic terms and definitions. (2014). Standartinform. [in Russian language].
3. Stepanov, M. V. (2025). Influence of temperature on the metrological characteristics of fiber-optic sensors with a closed optical channel. Kontrol'. Diagnostika, (6), 40–45. [in Russian language].
4. GOST 13320-81: Automatic industrial gas analyzers. General specifications. (1989). Standards Publishing House. [in Russian language].
5. Hodgkinson, J., & Tatam, R. P. (2013). Optical gas sensing: A review. Measurement Science and Technology, 24(1), Article 012004.
6. Hodgkinson, J., & Tatam, R. P. (2013). Non-dispersive infra-red (NDIR) measurement of carbon dioxide at 4.2 μm in a compact and optically efficient sensor. Sensors and Actuators B: Chemical, 186, 580–588.
7. Wong, J. Y., & Schell, M. (2011). Zero drift NDIR gas sensors. Sensor Review, 31(1), 70–77. https://doi.org/10.1108/02602281111099116
8. Dinh, T.-V., Son, Y.-S., Kim, J.-C., & Choi, I.-Y. (2016). A review on non-dispersive infrared gas sensors: Improvement of sensor detection limit and interference correction. Sensors and Actuators B: Chemical, 231, 529–538.
9. Tan, X., Zhang, H., Li, J., et al. (2020). Non-dispersive infrared multi-gas sensing via nanoantenna integrated narrowband detectors. Nature Communications, 11(1). https://doi.org/10.1038/s41467-020-19085-1
10. Jha, R. K. (2018). Non-dispersive infrared gas sensing technology: A review. IEEE Sensors Journal, 18(12), 4736–4748.
11. Bogue, R. (2015). Detecting gases with light: A review of optical gas sensor technologies. Sensor Review, 35(2), 133–140.
12. Ishanin, G. G. (1980). Radiation receivers. Energiya. [in Russian language].
13. Kochelaev, E. A., & Petrov, V. V. (2023). Development of a compact optical carbon monoxide sensor with a threshold sensitivity of 1 mg/m³ (0.85 ppm). Assessment of measurement selectivity. Optika i spektroskopiya, 131(10), 1431–1440. [in Russian language].
14. Zhang, Y., Jiang, P., Cao, W., et al. (2020). High-sensitivity ethylene gas sensor based on NDIR and dual-channel lock-in amplifier. Optik, 223, Article 165630. https://doi.org/10.1016/j.ijleo.2020.165630
15. Zhou, Y., Zhang, C., & Wang, H. (2015). Perspective on CO oxidation over Pd-based catalysts. Catalysis Science & Technology, 10, 695–711.
16. Chen, J., Su, Y., & Meng, Q. (2023). Palladium encapsulated by an oxygen-saturated TiO₂ overlayer for low-temperature SO₂-tolerant catalysis during CO oxidation. Angewandte Chemie International Edition, 62(49). https://doi.org/10.1002/anie.202310191
17. Wang, C., Li, X., & Yuan, S. (2024). Oxidative coupling of carbon monoxide to dimethyl oxalate: Catalysts design, reaction mechanism and process intensification. Catalysis Reviews: Science and Engineering, 66(5), 1855–1890. https://doi.org/10.1080/01614940.2024.2320165
18. Liang, X., Wang, X., Zhang, L., & Song, S. (2023). ZnCo₂O₄ supported low-loading Pd as an enhanced catalyst for low temperature oxidation of carbon monoxide. Chinese Journal of Structural Chemistry, 42(7). https://doi.org/10.1016/j.cjsc.2023.100101

+ - Purchase digital version of a single article Click to collapse

This article is available in electronic format (PDF).

DOI: 10.14489/td.2026.06.pp.072-078

Copy the article DOI and follow the link https://id-spektr.ru/product/pokupka-elektronnoy-stati-iz-zhurnala-kontrol-diagnostika

Please specify the article DOI in the order comments.